Testing and Replacing a Whirlpool Refrigerator Thermostat

If you want to know how test and replace Whirlpool Refrigerator Thermostat, follow this article and get more information ...!!!

A Whirlpool Refrigerator Thermostat can be fail in two ways:

1. Open Position

2. Closed Position

If the Whirlpool Refrigerator Thermostat fails in the open position, then unit will not run all time. Remove the screws from the evaporator housing and pull the housing down(make sure that unit is unplugged). Locate all the wires attached to the thermostat and remove them. You can connect the two wires together and tape with electrical tape. Plug the unit back in or turn on the breaker. When unit runs then replace the thermostat.

If the Whirlpool Refrigerator Thermostat fails in the closed position, the unit will run all the time. Running Refrigerator Thermostat constantly will cause the evaporator to freeze up and it will restrict the airflow and causing the temperature to rise. Follow the same instructions which described above to test the unit and replace the refrigerator thermostat if necessary. Also be sure to deliquesce the evaporator before turn the unit back on.

Suppose, if the evaporator continues to freeze up after replacing thermostat, call to the service company or else you can contact us to know other problems and get a immediate solutions. 

Low Pressure Control: This is also a type of control. Low Pressure Control is located in the compressor compartment. This connected into the refrigeration lines, controls the temperature by using pressure of refrigerant flowing through the line. To replace Low Pressure Control we need a service technician to fix the problems.

To buy online or if you need any help, visit us at:  http://appliancesparts.in/